SAM4S ER380 / ER420 Basic Set Up Guide

Basic Set Up Guide For ER380/M and ER420M prior to AU versions.

 

 

  • Performing the ram clear
    1. Turn Power off to the register (power on/off right hand side)
    2. Using the ‘C’ key insert and turn to the service mode, [one turn past “P” position (6 o’clock)
    3. Whilst the power is off hold down the “Check” key and turn the power back on
    4. !!!!!Wait for the beep!!!!! Then release the “check” key
    5. Push and release in sequence top left button, bottom left, top right and finally the CASH key. (This will take some time)

NOTE è The ram clear is a key step you should only do this once, as It will delete all data programmed inside the register and set back to the factory default

 

Turn the Mode Key to the PGM position

SYSTEM OPTIONS

  1. 30 SUBTOTAL
  2. 6 X/TIME 1 SUBTOTAL (Allow post tender)
  3. 24 X/TIME 3 SUBTOTAL (Activate EJ)
  4. CASH to finish

 

Time & Date            

  1. 1300 SUBTOTAL
  2. HHMM X/TIME
  3. MMDDYY X/TIME
  4. CASH

           

PLU STATUS Programming

To program a PLU with a preset price And GST

  1. Turn Key to Program Mode
  2. 100 Subtotal
  3. Push Desired PLU or scan barcode
  4. 4 0 0 0 0 0 0 0 0 X/TIME
  5. Press Cash

 

To program a PLU with an open price and GST

  1. 5 0 0 0 0 0 0 0 0 X/TIME

 

To program a PLU with an open price and without GST

  1. 1 0 0 0 0 0 0 0 0 X/TIME

 

To program a PLU with a preset price and Scaleable NO GST

  1. 1 0 0 0 4 1 0 0 0 X/TIME

 

PLU DESCRIPTION PROGRAMMING

  1. Turn Key Lock to P Position
  2. 300 SUBTOTAL
  3. Select Plu For description
  4. Using the asci code sheet enter in the description for the PLU (18 Characters MAX)
  5. Or enter using alpha overlay
  6. The X/TIME Key
  7. Repeat Steps 1 è 5 until done
  8. Cash

 

PLU PRICE  PROGRAMMING

  1. 200 SUBTOTAL
  2. press item button
  3. enter price
  4. X/TIME
  5. Using the asci code sheet enter in the description for the group (Remember only 18 characters)
  6. Or enter using alpha overlay
  7. Subtotal
  8. Repeat steps 1 è 5 until done
  9. Cash

 

PC setup on port 1

80 Subtotal 5 x/time 1 CASH CASH

 

Turn the mode key to back to Register Press 1 Clerk Button and begin operations as normal